
Cleaner pavers with full, freshly sanded joints
Paver Cleaning and Joint Sand in Mount Dora, FL
Ask for a free paver cleaning estimate in Mount Dora, or call (352) 820-4633.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get my Mount Dora pavers cleaned without a long wait?
A local contractor cleans pavers around Mount Dora, FL, and a reply reaches you within 1 business day, usually much sooner. New joint sand is part of the job, and the free estimate carries no pressure to book. To start, call (352) 820-4633.
Washing removes the algae, grime and stains that dull pavers, which brightens the surface and improves grip underfoot. Fresh sand then fills the joints, which steadies the pavers and crowds out weeds. A back walk that went green under the oaks can match the rest of the yard again. Point the contractor to the worst patches when you ask for a free Mount Dora estimate.
Paver Sealing Mount Dora Is Proud to Serve Central Florida

What is part of a paver cleaning job?
The job covers stain and algae treatment, a gentle wash and new joint sand once the surface dries. You can book it alone or as the first half of a sealing visit. Shaded walks, damp patios and spots beside sprinkler heads usually take longest. To line up a cleaning, call (352) 820-4633.
Stain and algae treatment
Stains and algae get a treatment ahead of the wash. Paver Savers of Central Florida says oil and rust that sat for months may not come out.
Low pressure wash
Castle Clean and Seal uses a high volume, low pressure system, which lifts grime without blasting sand from the joints.
Fresh joint sand
Fine sand is swept into every gap and wet down to settle once the pavers have dried.
Sealer if you want it
Sealer can follow once every inch is dry. The sealing guide covers what it adds.
What are the signs my pavers need cleaning?
Watch for green or black film on shaded edges, dark streaks after wet weather, weeds in the joints and sand left on the driveway after a storm. Algae matters most of these, since a slick walk or pool deck can cause a fall. A Central Florida power cleaning company notes that a front walk can turn slippery after a summer shower. To have yours looked at, call (352) 820-4633.
Is a cleaning enough, or should I seal too?
A cleaning changes how pavers look today, while sealer decides how long they stay that way. Stopping at the wash costs less now, but algae, fading and sand loss return on their own timetable. The coat makes the next wash easier, though it has to be renewed within two to four years. Tell the contractor whether you want sealer added when you ask for a free Mount Dora estimate.
How often should Mount Dora pavers be cleaned?
Kennelly Paver and Restoration suggests a cleaning every 12 to 15 months to help a sealer last. A walk under oaks or a patio beside the lake may need it sooner, while an open, sunny driveway can wait longer. A wash after the summer storms clears a season of algae. To plan a rhythm for your yard, call (352) 820-4633.
Does a harder blast clean pavers better?
No. More force damages pavers and empties the joints without cleaning any better, which is why Castle Clean and Seal runs a high volume, low pressure system. Treating the stain first does the heavy lifting, and fresh sand goes back in once the surface dries. Ask what pressure and nozzle size the crew uses when you ask for a free Mount Dora estimate.
Ask where the wash water goes if your yard slopes toward a lake or a pond. The answer tells you how careful the crew will be around plants and the shoreline. To raise those questions now, call (352) 820-4633.
Why do Mount Dora pavers turn green so often?
Damp is what algae needs. A Central Florida power cleaning company says heat, afternoon showers and shade make it show up fast, and Kennelly says humidity feeds algae and mold on bare pavers. Mount Dora is in the same metro area as Orlando, which Kennelly puts at over 50 inches of rain a year. A wash after the rainy months holds up longer. To plan one, call (352) 820-4633.
What are the stubborn marks on my pavers?
Oil drips, rust rings and old set-in stains are the hardest to lift. Paver Savers of Central Florida treats stains before the wash but says some may not come out after months or years. Have the contractor try one small patch before committing. Point out the marks when you ask for a free Mount Dora estimate.
Why are white patches showing on my pavers?
A chalky white film is usually efflorescence, which Wikipedia describes as salt carried to the surface by water. It is often only cosmetic and usually brushes off. Point out the spot to the contractor when you phone (352) 820-4633, since old sealer can look much the same.
Which paved areas at a Mount Dora home can be cleaned?
A cleaning can reach any paved spot at the house, including the driveway, pool deck, lanai patio and front walk. Each collects a different kind of grime, so the method shifts. To start with yours, ask for a free Mount Dora estimate.
Driveways
Tires, oil and open sun reach the driveway before anything else. Cleaning here keeps the color even and the joints full where cars turn in.
Screened pool decks
Pool decks stay wet, and splash water and bare feet wear on them daily. Cleaning a pool deck should leave solid footing.
Patios and lanais
A patio under oaks or beside a lake stays damp and grows algae early. Cleaning a patio starts with a careful wash of the green spots.
Walkways and entries
Walks are narrow and sit close to the planting beds. Cleaning the front walk is a modest job that every guest sees first.
What leaves Mount Dora pavers dirty?
Algae in the shade, low joints, a white film, sun fade and tired old sealer lead the list. A cleaning handles some of these, and the rest need sealing or repairs. To check which fit your property, call (352) 820-4633.
1. Algae in shade and heat
A Central Florida power cleaning company says heat, afternoon showers and shade make algae show up fast. Oak-covered corners and north-facing walks turn green first and get slick.
2. Low or empty joints
Kennelly puts Orlando's rain at more than 50 inches a year, and Mount Dora is part of the same metro area. A cleaning is the time to refill the joints, since Kennelly says fresh sand keeps pavers from shifting.
3. A white, chalky film
Wikipedia explains that water can carry salts to the surface of masonry, and the result is often only cosmetic and brushes off. A sealer may slow it down, but it does not cure it.
4. Fading in open sun
A driveway with no shade sits in sun from morning until night. A wash shows how much color is left, and sealer afterward helps hold it.
5. Old sealer gone cloudy
Castle says a solvent-based coat can turn white and peel in Florida humidity, and a no-name sealer can break down in 6 to 12 months. Failed sealer must be stripped off before fresh sealer goes down.
What does paver cleaning cost in Mount Dora?
Central Florida companies price the wash, sand and sealer as one bundle at $1.50 to $3.00 a square foot, and Castle Clean and Seal does cleaning only alongside sealing on patios and walkways. Kennelly says an ordinary pressure wash runs about $0.15 to $0.75 a square foot, without sand or sealer. A cleaning-only visit gets its price after the contractor sees the surface. For a price on your property, ask for a free Mount Dora estimate.
Thinking of sealing too? Request a single combined price. Run the bundled rate on a 600 square foot driveway and you land near $900 to $1,800, with $500 to $1,000 or more added at Castle when failed sealer must be stripped. To compare the two routes, call (352) 820-4633.
Want the pavers protected too? See sealing for your pavers for that step. The service area list names each town reached, and Mount Dora paver sealing is the main page.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 500 sq ft | Lanai patio | $750 to $1,500 |
| 900 sq ft | Wide driveway | $1,350 to $2,700 |
| 1,400 sq ft | Driveway plus walkway | $2,100 to $4,200 |
Central Florida companies post cleaning, sand and sealer as one bundled rate, so this table uses the $1.50 to $3.00 a square foot published as of November 2026. Kennelly puts an ordinary pressure wash at $0.15 to $0.75 a square foot, which covers no sand and no sealer. Your quote may differ.

Why use a local contractor for paver cleaning?
A contractor who works around Mount Dora knows what a wet summer and oak shade leave behind. Set the quote beside the published rates on this page, then take your time deciding. To begin, ask for a free Mount Dora estimate.
Contractors who know the lake country
A company that works around Lake Dora and the towns beside it plans for shade, humidity and afternoon storms. The first visit goes faster as a result.
A free look, a free number
Nobody charges for the estimate, and you can say no once you see the price. Whether you book is entirely your call.
A price range you can check
Central Florida companies post their per square foot rates, and this site lays that range out in plain numbers. A bid far outside it is worth a question.
Time to decide
Ask for the price in writing and take a few days if you need them. When you are ready to compare, the contractor standards page lists what to confirm.
Want a free estimate to clean your Mount Dora pavers?
Send the short form or call, and a contractor replies inside 1 business day, often far sooner.
Free, no obligation

What do cleaned pavers look like around Mount Dora?








How does the paver cleaning process go, step by step?
If you skip sealer, the visit ends after step four, when the joints are full. To set a date, call (352) 820-4633.
1. Measure and look it over
The contractor measures the area for the cleaning quote and notes low spots, loose pavers, old sealer and anywhere water sits.
2. Treat and wash
Beds, screens and the garage door are covered first. Stains and algae are treated first, then the surface is washed at a pressure that leaves the sand in place.
3. Let it dry
Sealer needs a dry surface, and Castle puts Central Florida humidity at 80 percent or more, so the wait follows the weather.
4. Fill the joints
Fine sand is swept into every gap, wet down to settle it, and the extra is cleared from the surface.
5. Seal and walk it with you
If sealer is included, it goes down in even coats. Last, the contractor walks the area with you and gives the wait times for feet, furniture and cars.
Frequently Asked Questions
How much does it cost to clean and seal pavers?
Central Florida companies publish $1.50 to $3.00 a square foot for the full clean, sand and seal. A 600 square foot driveway in Mount Dora would run about $900 to $1,800. One company holds a $1,000 project minimum, and stripping failed sealer costs extra.
Should pavers be cleaned before they are sealed?
Yes. Castle Clean and Seal treats algae and weeds first, washes at low pressure and sands the joints before any sealer goes on. A coat over grime holds the grime in place.
Should you seal pavers after power washing?
Usually, if you want the color and the clean to last. Kennelly describes sealer as a breathable, waterproof barrier that goes onto a clean, sanded surface, and Paver Savers of Central Florida says it only slows algae and fading. The trade is a fresh coat every two to four years.
Is it a good idea to pressure wash pavers?
Yes, when the wash is low pressure and the joints are refilled afterward. Castle describes a high volume, low pressure system and warns that too much pressure damages the surface.
Does a paver cleaning include new joint sand?
It should. Castle counts wet-sand joint stabilizing inside its bundled rate, and Paver Savers of Central Florida sands the day after the wash. Confirm that sand appears in your written quote.
Can a cleaning remove rust and oil stains from pavers?
Sometimes. Paver Savers of Central Florida treats stains before the wash but says oil and rust that has sat for months or years may not come out. A small test patch will show what to expect.
Why do pavers in Mount Dora turn green?
A Central Florida power cleaning company says heat, afternoon showers and shade make algae show up fast. Kennelly adds that humidity feeds algae and mold on bare pavers. Oak shade and lake dampness speed it up.
How soon can my Mount Dora pavers be cleaned?
A contractor replies within 1 business day, usually much sooner, and the work itself takes one or two days, weather permitting. A wet week can move the date back.
How long does paver sealing last in Florida?
Two to four years, according to Kennelly. A cleaning every 12 to 15 months helps it last, and Castle says a no-name sealer can break down in 6 to 12 months.
Pick a day to freshen your Mount Dora pavers
Send the short form or phone, and a local contractor answers inside 1 business day, often far sooner.
Free, no obligation
